Functional from All Angles
Better by design, the iWALK 2.0 hands free crutch is functional, strong, easy to use and easy to adjust. Because no two legs are equal, it has a host of features that allow you to tailor it to your size, height, and leg style.
iWALK 2.0 Primary Adjustments
Push button spring adjustment works similar to standard crutches. Allows you to tailor to the length of your upper leg and lower leg independently. Always adjust the upper leg length as high as possible so that Thigh Supports are at the very top of your leg.
Upper leg adjustment range: 12.0” – 18.0”
Lower leg adjustment range: 13.75″ – 20″
The Thigh Supports recruit the upper leg to align and stabilize the crutch. Adjusts for thigh circumference from 15.5” to 28.0”. Left and Right are independently adjustable.
CALF STRAP SLIDER MOUNT
The Calf Strap Mounts are on rails that run along the length of the Knee Platform. They can be repositioned by hand along the length of the rails to allow you to position the Calf Strap forward or back on the Knee Platform. You use this in cases where the standard Strap position (at the back of the Knee Platform) might irritate your injury. Below knee amputees will typically position the strap further forward to accommodate their residual limb.
iWALK2.0 Other Technical Features
Gives user confidence and aids in initial learning. Often used for longer distances to improve efficiency. Used for short distances to keep crutch aligned and in contact with the user’s leg when walking without straps. Also used when treating the crutch like a cane for assisting in getting up from seated position.
2. QUICK RELEASE BUCKLES
Quick release buckles allow you to quickly put on or take off the crutch. After basic proficiency is achieved, most people can don / doff the crutch in 10-15 seconds. As an additional safety feature, straps must be loosened fully before buckle can disengage. Converts tool-free for Left or Right leg use.
3. STRAP – TIGHTEN / LOOSEN SECTION (ON/OFF)
Proper tensioning of the strap is essential to give you maximum control and safety. This section, denoted by the Gray buckles, is ergonomically positioned on the outside of your leg, allows you to fully and significantly tension the strap with a quick pull on the end of the strap. A quick lift of the buckle releases tension so you can quickly take the crutch off.
4. STRAP – LENGTH ADJUSTMENT SECTION
This section of the strap, denoted by the Black buckles, is used only for your
initial setup and fitting of the crutch. Once you have achieved the proper length / pre-tension, you shouldn’t ever need to adjust it again. Fits legs up to 28.0” in circumference.
5. KNEE GATE STRAP
Can be positioned higher or lower to fine tune your positioning on the Knee Platform. For thinner users, keeps upper leg from going between the Upper Assembly tubes. Features non-slip silicone so it stays in place when not in use.
6. PLATFORM PAD
New 3 layer, dual density pad provides best combination of comfort and control. Top layer will conform and shape itself to match your leg. Lower layers absorb shock and provide cushion for comfort. Padding is closed cell and will not absorb moisture.
7. KNEE PLATFORM
Anatomically designed structurally reinforced platform is light weight and
extremely stiff for maximum control. Your weight is distributed along the length of your shin to allow maximum comfort. Composite reinforced material with structural grid provides exceptional stiffness while maintaining light weight. Ergonomic shape fits the contours of the lower leg.
8. CLAMP NUT AND BOLT
Tightens and loosens by hand to lock in all upper and lower section height adjustments. When tightened, height adjustments are intentionally difficult or impossible, so loosen before making height adjustments, and always tighten before using the crutch.
Our patented Foot is offset to the outside to provide stability, balance and control. Easy tool free adjustment allows Left of Right foot use. Includes our proprietary Vibram ™ tread for wet and dry traction, long wear and shock absorbing.