assemble iwalk 2.0

Assemble iWALK 2.0

built-crutch

Detailed structure of iWalk 2.0

Assembly is easy!

Please follow along the step by step
instructions in this video or the tabs below:

a. Upper Assembly

b. Knee Platform

c. Lower Assembly

d. Support Tubes

e. Clamp Bolt and Nut

f. Straps

components

download-pdf
To download the PDF version of the detailed instructions click here

A. With the handle facing forward, insert the tubes of the Upper Assembly into the sockets of the Knee Platform.

attention
If the hole at the bottom of the left tube does not align with the hole in the platform, simply rotate the tube until it does.

connecting-sections

A. Identify the Right side Support Tube by the small “R” stamped near the top. Press in the small silver button and insert the Support Tube into the bottom of the Knee Platform socket until the button springs into the hole.

Make sure the two tubes and the Knee Platform are securely locked together.

Next, insert the left Support Tube.

connecting-sections-A

B. Attach the Lower Assembly to the Knee Platform by pressing in the silver button on the Height Adjustment Tube and inserting the tube into the socket of the Knee Platform. Tug on the tube to confirm that it is securely locked in.

connecting-sections-B

C. Position the Clamp so it aligns between the ends of the support tubes.  You can use gentle pressure to move the Support Tubes while you rotate the Clamp into postion.
Gently push the support tube ends and align all 4 holes, then insert the Clamp Bolt through the holes. Thread the nut onto the end of the bolt.  Do not tighten completely yet.

connecting-sections-C

download-pdf
To download the PDF version of the detailed instructions click here

Insert the Thumb Screw into the slot on either side of the Handle. Align the hole in the top of the Thigh Support with the threaded end of the Thumb Screw.
Thread the Thumb Screw into the nut located below the surface of the Thigh Support.  As you tighten, insure that the interlocking teeth mesh correctly.  Finish tightening the Thumb Screw by hand.
Repeat on other side. Flex the Thigh Supports in and out to make sure they are secure.

attentionBefore attaching the Thigh Support to the handle, note that there are raised “teeth” on the upper surface of each Thigh Support and on the lower surface of the Handle. These teeth will interlock to prevent rotation of the Thigh Supports when the crutch is in use.

download-pdf
To download the PDF version of the detailed instructions click here

thigh-support

Align the hole in the Strap T Lock Buckle with the raised “T” lock on the Thigh Support.  Pull back on the buckle to lock it in.  Repeat for the other side of the strap. To remove the buckle, simply push forward on the buckle until it releases.

attentionThe Gray buckle should be located on the outside of your leg. Crutches ship configured for right leg use.  To change to left leg use, simply remove and reverse the straps, and rotate the foot 180 degrees.

download-pdf
To download the PDF version of the detailed instructions click here

straps
built-crutch

download-pdf
To download the PDF version of the detailed instructions click here

Next

assembled
fit-it
use-it
questions-or-concerns

Still have questions or concerns?

We’re here to help. Check our Frequently Asked Questions or contact us.

Back To Top